Matt,
When i go to make an AT5 file from my sidescan mosiac on version 1.7 after it creates the mosiac and the IMC pops up it they shows error and this pops up. It has happened on ver 2.0 as well. Any help would be greatly appreciated.

Jason

How long does the IMC run for? Does it show an error message or just finish/crash? The error in RM is just that there were no output files produced by the IMC. This could be for a number of reasons, so hard to pin down from the info you have provided. How big is the mosaic when you consider the enclosing rectangular extent? Can you export the mosaic from RM in an image format (e.g. MBTiles)?

I would say it kicks out the error message after about 10 min. Usually happens right after it has created mosiac. Then IMC pops up. After that 5 or 10 min tops. This mosiac is only 13750 feet by 7950 feet. And the mosiac is not solid completely in that area. It will create a MB Tile and also the KML super overlay. Makes me think it is something in the IMC rather than reefmaster.

Matt,

I went and changed the location of my IMC and it is running good so far. It is still process but has gotten past the normal hang up. I will let you know if it gives me any more problems. Thanks for your help.

Jason

OK thanks Jason. That is an interesting one if it turns out to be the issue - where was it stored before?