Hi,
This is perhaps the wrong place for this topic, but on the other hand, there are a lot of Lowrance users on this forum so maybe someone else has had this issue.
Or maybe someone who work with Lowrance (developer) reads this and brings it up internally.
I have written to Lowrance support regarding this issue, but they didn't have a clue, and honestly, they didn't seem to be too interested in finding out what is causing this isue. They stopped responding after my last comment, so I suppose they got offended in some way.
Please find my email correspondence with Lowrance below (my comments in blue, Lowrance in red). Enjoy the ride ;-)
Hi, I have noticed some strange behavior from my HDS10 Gen 2 for some time.
Currently I use the 3.0 software, but the problem was already present before the last update. The symptom is that the “Heading extension line” goes crazy for a short while. The symbol starts spinning around in different directions, and the length of it also changes rapidly. The symptom shows irregularly with no obvious logic or pattern.
Normally I see this behavior after some time of operation, so the GPS has definitely had the time to acquire good data. My boat has been moving in a relatively straight line in 3-4 knots during all episodes, so there is no excessive maneuvering. I have always been on an open water with no obstacles and no transmitters in the vicinity. SBAS (EGNOS) has been activated. I have not verified the GPS constellation for my location during the episodes, but since PRN 06 and PRN 30 are unhealthy, there is a risk that they can induce bad data, possibly causing this type of behavior, unless the implementation filters out bad satellites. See notice from USCG: www.navcen.uscg.gov/pdf/gps/GPSOC_PRN%2030_Notice.pdf
So, Is this a known bug? Does the HDS software handle and filter out bad satellites today? Will an excessive COG/SOG (position is unaffected) have any impact of the sonar recordings? I have been recording sonar data during some of the episodes. I can send you the SL2 log if you believe it would help finding the cause for this behavior.
Thank you for your inquiry.
Are you using the internal antenna or an external antenna?
Thank you for choosing Navico products!
Navico Technical Support
Thank you for quick reply.
I am only using the internal GPS antenna.
No other equipment than the LSS-2 module is connected to the HDS.
//Mats
Thank you for your inquiry.
Do you have the unit mounted by a compass or any other devices?
Thank you for choosing Navico products!
Navico Technical Support
Hi,
No compass and no other electronics.
Though, sometimes I have a cellphone (3G) in the fishing trunk, but at least more than three feet away.
//Mats
Thank you for your inquiry.
What is the chart orientation set on heading up, course up, or north up?
Thank you for choosing Navico products!
Navico Technical Support
I am only using North up.
//Mats
Thank you for your inquiry.
We recommend the unit come in for service. What is your address and the 9 digital serial number off the back of the unit?
Thank you for choosing Navico products!
Navico Technical Support
Hi,
The serial number is: 104 464 xxx
Though, I live in Sweden now, so it would not be practical to send the unit in for service.
And honestly I doubt that there will be any problem with the hardware. This is a typical software issue.
I never got any answer regarding the integrity check of the GPS data. Do you validate the quality of the GPS data?
Could the corrupt data of PRN 06 and PRN 30 cause this behavior?
Are there any filtering of excessive/unlikely values before the GPS data gets used?
I am working technically with GNSS and AIS systems on a daily basis. It is my profession to analyze and troubleshoot these kind of issues, so please take this question to the next level, like second or third line of support. I believe a software developer needs to take a look at it. And as I wrote earlier, I can send you a log file.
Regards
//Mats